Pass Juniper JN0-1362 PDF Dumps | Recently Updated 130 Questions
Updated Test Engine to Practice JN0-1362 Dumps & Practice Exam
NEW QUESTION 27
Your customer wants an MPLS-based L3VPN service between multiple remote locations.
Which two statements are true regarding the customer's WAN edge devices? (Choose two )
- A. They require IP connectivity with the PEs.
- B. They must have EBGP configured.
- C. They must have MPLS configured.
- D. They require routes for all remote sites.
Answer: A,D
NEW QUESTION 28
Which two network availability features require a router to have two Routing Engines installed? (Choose two.)
- A. nonstop routing
- B. JVRRP
- C. GRES
- D. graceful restart
Answer: A,B
NEW QUESTION 29
You are designing several MPLS virtual routing and forwarding (VRF) instances on all provider edge (PE) routers. Routes within each VRF should be exchanged between all PE routers provisioned for that VRF.
For each VRF routing instance which two attributes must match on all related PE routers? (Choose two )
- A. router ID
- B. VRF target
- C. instance type
- D. interfaces
Answer: B,C
NEW QUESTION 30
A customer reports a network outage at a branch office after users have reported intermittent Internet connectivity Upon further investigation, you determine that there is significant packet loss and that the majority of traffic on the WAN consists of DNS responses from many different sources.
In this scenario, which design consideration would reduce further occurrences with minimal chance of affecting valid traffic?
- A. Configure BGP flowspec.
- B. Create a firewall filter to drop all traffic to the affected destination address of the attack
- C. Implement CGNAT
- D. Create a firewall filter to drop all traffic based on the source addresses of the attack.
Answer: C
NEW QUESTION 31
MPLS services are being delivered from provider edge (PE) routers Each PE is connected to multiple customer edge (CE) routers.
What should you use on the PE to isolate customer routes?
- A. VPN routing and forwarding tables
- B. external BGP
- C. access control lists
- D. port access control lists
Answer: A
NEW QUESTION 32
Exhibit.
You want to design a VPN service that will allow your enterprise the ability to span their VLANs between the four sites shown in the exhibit, while allowing point-to-multipoint connectivity.
Which two MPLS VPN technologies allow this type of functionality (Choose two.)
- A. Layer 3 VPN
- B. VPLS
- C. Layer 2 VPN
- D. EVPN
Answer: A,D
NEW QUESTION 33
A customer wants to consolidate all remote site connections into a single enterprise WAN for backhual to the corporate headquarters and data centers.
Which solution satisfies this requirement?
- A. private WAN
- B. Internet edge
- C. WAN aggregation
- D. Data Center Interconnect
Answer: D
NEW QUESTION 34
Which two statements are correct about Junos Space Connectivity Services Director? (Choose two)
- A. It is used to design and simulate MPLS-TE and LSP routing.
- B. It is used to provide zero touch provisioning (ZTP), which simplifies the deployment of networks by providing policy-driven plug-and-play provisioning and network bring-up operations.
- C. It is used to design, provision, and monitor Label Discovery Protocol (LDP) and Border Gateway Protocol (BGP) services on devices
- D. It is used to design, provision, and deploy MPLS-dynamic, RSVP-signaled LSP, and static LSP services on devices.
Answer: B,D
NEW QUESTION 35
Your customer requires redundant routers and wants to use VRRP for the default gateway at their Internet edge.
Which two statements are correct in this scenario? (Choose two )
- A. The VRRP master and backup send advertisements to each other at regular intervals.
- B. VRRP dynamically elects master and backup routers
- C. VRRP for IPv6 provides a much faster switchover to an alternate default router than IPv6 neighbor discovery procedures
- D. VRRP will only support two routers
Answer: A,B
NEW QUESTION 36
You are designing a new service provider network and need to select a label distribution mechanism that guides certain types of traffic along specific paths within the network.
Which two label distribution mechanisms would satisfy the requirements? (Choose two.)
- A. LDP
- B. segment routing
- C. BGP-LU
- D. RSVP
Answer: A,D
NEW QUESTION 37
You work for a service provider that offers Layer 2 services. One of the customers is purchasing Layer 2 VPN services to interconnect several sites.
In this scenario, which two functions are provided by the PE router? (Choose two )
- A. It maintains an MP-BGP session with each customer site to exchange customer routing information
- B. It maintains MPLS LSPs between the sites.
- C. It maintains all customer Layer 3 routing information.
- D. It selects the appropriate Layer 2 VPN in the service provider network.
Answer: A,C
NEW QUESTION 38
You are designing a solution for an energy trading organization that allows them to stream natural gas prices to trading partners. Prices will be streamed to trading partners using the Internet. Trading regulations require that any trading data streamed over a public network must be encrypted and authenticated.
Which connectivity solution meets these requirements?
- A. VPLS
- B. IPsec
- C. L2VPN
- D. L3VPN
Answer: B
NEW QUESTION 39
You are implementing an MPLS-based WAN environment to connect remote sites to the corporate headquarters (HQ) However, the service provider at the HQ location does not provide service at the location of one of the remote sites.
Which statement is true in this scenario?
- A. A circuit can be bridged across multiple service providers for end-to-end connectivity.
- B. A public WAN circuit can be provisioned over the Internet that will provide the same level of service.
- C. A hub site in a location where both service providers have a presence will need to be deployed.
- D. A dedicated leased line will need to be used to connect to the remote site.
Answer: A
NEW QUESTION 40
You are asked to design a WAN for a large enterprise. Each site must have multiple connections for redundancy. MPLS is not available at every site but it is preferred where available.
Which topology satisfies these design requirements?
- A. hub-and-spoke Internet WAN
- B. full mesh SD-WAN
- C. full mesh MPLS VPN
- D. hub-and-spoke SD-WAN
Answer: D
NEW QUESTION 41
You work for a service provider that offers L3VPN services to its customers. While designing L3VPN solutions for customers, you sometimes need to share routes between routing instances as part of the design.
What are two reasons for sharing routes between routing-instances? (Choose two)
- A. to support network address translation
- B. to allow the service provider's OoB network to be reachable by customers
- C. so customers can reach the service provider's public cloud infrastructure
- D. so customers can reach the Internet
Answer: C,D
NEW QUESTION 42
Exhibit.
Referring to the exhibit considering shared fates, which Internet Transit?
- A. Customer B
- B. Customer C
- C. Customer A
- D. Customer D
Answer: A
NEW QUESTION 43
What are two ways to provider redundancy in a WAN design to address physical failures? (Choose two.)
- A. Select products with different types of MICs.
- B. Select products with different versions of firmware.
- C. Select products that use MC-LAG.
- D. Select products that use multiple Routing Engines.
Answer: A,B
NEW QUESTION 44
Which management platform automates and simplifies the management of Juniper Networks switching, routing, and security products?
- A. Juniper Secure Analytics
- B. Junosphere
- C. Junos Space
- D. Junoscope
Answer: C
NEW QUESTION 45
As a service provider network architect, you are working with a potential customer who wants to replace their WAN, consisting of two data centers, one HQ, and 76 branch offices Due to application latency requirements between branch offices, the customer insists that all traffic must take the most optimal path through the service provider network. The customer intends to encrypt all traffic between customer routers at each location.
Which WAN technology would you propose in this scenario?
- A. point-to-point Layer 2 VPNs
- B. H-VPLS
- C. Internet as WAN
- D. Layer 3 VPN
Answer: C
NEW QUESTION 46
You are developing a CoS policy for a service provider core network that In this scenario, which three statements are correct? (Choose three.)
- A. Core routers should use a consistent CoS configuration across the network.
- B. Core routers should use the DSCP markings already set on ingress traffic.
- C. Core routers should use policers to ensure that customer traffic does not exceed allowed bandwidth.
- D. Core routers should use a common set of per-hop behaviors.
- E. Core routers should use shapers to ensure that customer traffic does not exceed allowed bandwidth.
Answer: B,C,D
NEW QUESTION 47
Your company is designing a new data center in a remote location that must be connected to your local data center. You have a service provider connection between the CE devices at each site. You want to implement EVPN with VXLAN services between sites, but the service provider does not offer EVPN services.
Which two statements are true in this scenario? (Choose two )
- A. The service provider must provide an MPLS-based VPN connection between sites
- B. You can still implement EVPN service across the service provider as long as there is IP reachability between the sites.
- C. The customer's edge devices within your data center can act as VXLAN Layer 2 gateways
- D. The provider's edge devices must map your VXLAN VNIs to MPLS LSPs within the provider network at each site
Answer: B,C
NEW QUESTION 48
You are designing an EVPN data center solution with VXLAN.
Which two statements are true in this scenario? (Choose two)
- A. The original MAC address is replaced by a VXLAN VNI.
- B. The original MAC address is encapsulated within the VXLAN frame.
- C. The original MAC address is advertised to remote PEs.
- D. The original MAC address is prepended to a VXLAN VNI.
Answer: B,C
NEW QUESTION 49
......
Juniper JN0-1362 Dumps Cover Real Exam Questions: https://www.pass4surecert.com/Juniper/JN0-1362-practice-exam-dumps.html