Free Nutanix NCS-Core Test Practice Test Questions Exam Dumps
Prepare Top Nutanix NCS-Core Exam Audio Study Guide Practice Questions Edition
NEW QUESTION 71
An administrator needs to initiate a new VDI project within a couple of months. Prism Central reports there are no storage resources to accommodate such workloads.
The administrator sees many powered-off VMs and has the authority to delete test VMs powered off at least for 30 days. Test VMs belong to the Test category.
Using Prism Central, which steps are required to identify the correct VMs tobe deleted?
- A. Use Capacity Runway to filter by Test and Powered-off VMs
- B. Create a new Scenario selecting Test VMs. filter by uptime
- C. Create a new Project selecting Test VMs,sorting by power state
- D. Filter VMs list, choose Test category and Inactive under Efficiency
Answer: D
Explanation:
NEW QUESTION 72
To prepare for a new Nutanix installation, a consultant downloads the Foundation VM, imports the VM to their Desktop Virtualization Solution, and powers on the VM. The IPv4 static address on the host workstation and the Foundation VM have been configured, but pings between them fail.
Which two troubleshooting steps should the consultant perform? (Choose two.)
- A. Verify the virtual NIC in the Foundation VM is bound to the correct wireless network adapter.
- B. Remove and re-import the Foundation VM to ensure the virtual NIC is set to Host-Only.
- C. Verify the virtual NIC in the Foundation VM is bound to the correct physical Host adapter.
- D. Confirm the IP addresses and subnet masks are correct.
Answer: C,D
NEW QUESTION 73
An administrator is configuring software only. Data-at-Rest Encryption on their Nutanix cluster. They are planning to deploy a third-party key management server (KMS).
Where should this server be hosted?
- A. On hardware external to the Nutanix duster
- B. As a single VM on the Nutanix cluster
- C. As a clustered VM setup on the Nutanix cluster
- D. As a single VM deployed on the host that contains the Prism leader CVM
Answer: A
Explanation:
NEW QUESTION 74
An administrator is planning to deploy a Nutanix cluster to support a few high-performance VMs. This deployment will have the followingconsiderations:
* Individual VMs will likely generate network throughputs in the range of 90-100Mbps
* Due to the configuration of the VMs, it is unlikely that a node will host more than one or two of them at a time
* Individual VMs will communicatewith only a few (one or two) remote hosts at a time
* Multicast will not be used in the environment
* The hosts are connected via two 1GbE network connections
How should the administrator configure the network bonds to meet this requirement while maintaining the simplest switch configuration?
- A. Configure bond0 as balance-sib
- B. Configure bond0 as active-backup
- C. Configure bond0 as balance-tcp
- D. Configure bond0 as balance-lacp
Answer: A
Explanation:
Explanation
Ref:https://portal.nutanix.com/page/documents/solutions/details?targetId=BP-2071-AHV-Networking:top_ahv_n
NEW QUESTION 75
An administrator has two clusters: Site A and Site B.
Async DR is configured between the clusters as follows:
* Site A is the Primary Site
* Site B is the Secondary inactive Site, no VMs running
* Site A is fully in Production
* Site B used as Backup/Disaster Recovery
The customer wants to perform a planned failover between the sites.
How should the administrator accomplish this?
- A. Click Activate on the Secondary site within the Data Protection Dashboard
- B. Choose Migrate on the Secondary site within the Data Protection Dashboard
- C. Click Activate on the Secondary site and run deactive NCLI command on Primary site
- D. Choose Migrate on the Primary sitewithin the Data Protection Dashboard
Answer: D
Explanation:
Explanation
Ref:https://portal.nutanix.com/page/documents/details?targetId=Web-Console-Guide-Prism-v510:wc-protection-
NEW QUESTION 76
A consultant is onsite with a customer running Foundation VM (FVM) and discovers that there is no connectivity between the FVM and their laptop. The consultant verifies the following:
* The consultant's laptop and Nutanix nodes are plugged into a flat switch.
* The laptop, switch and nodes are plugged into supported power supplies.
* The laptop network adapters and FVM are configured with their corresponding IP addresses.
What is the cause for the connectivity failure to the FVM?
- A. Laptop WiFi configured to use DHCP.
- B. The switch is not plugged into the power supply.
- C. Desktop Firewall is blocking ping requests.
- D. Network cables are not connected.
Answer: C
NEW QUESTION 77
An administrator is monitoring the Nutanix v5.15-based AOS cluster performance logs and notices that a SQL server VM is greatly exceeding its intended maximum IOPS.The administrator has confirmed that a QoS policy was previously created for the group of VMs this server is a member of.
What are two reasons that this VM would exceed its maximum configured IOPS from the QoS Policy?
(Choose two.)
- A. The SQL Server VM has volume groups attached.
- B. The VM was not created as an AFS virtual machine.
- C. The VM is missing the required snapshot needed to implement the QoS Policy.
- D. It was cloned from another SQL Server VM that was a member of the QoS Policy.
Answer: A,B
Explanation:
Explanation
Ref:https://portal.nutanix.com/page/documents/details?targetId=Prism-Central-Guide-Prism-v5_18:mul-storage-
NEW QUESTION 78
A VM is exhibiting one or more of the following baseline values based on the past 30 days:
* CPU usage < 20%
* CPU ready time < 5%
* Memory usage < 50% (moderately) or < 20% (severely)
* Memory swap rate = 0 Kbps
Which type of VM is being described?
- A. Over-Provisioned VM
- B. Constrained VM
- C. Bully VM
- D. Inactive VM
Answer: A
Explanation:
NEW QUESTION 79
In a Nutanix cluster, a Protection Domain contains 50 entities that are replicated to a remote Single Node Replication Target.
The current schedule configuration is as follows:
* Repeat every 6 hours
* Local Retention Policy 1
* Remote Retention Policy 8
* Starting time 12 am
At 8 am on Monday, the administrator discovers that a protected VM is corrupted. The latest good state was Sunday 2 pm. The administrator needs to maintain current protection.
Which strategy should the administrator use to meet these requirements?
- A. From the local site, restore the VM from the local snapshot by selecting the correct snapshot.
- B. From the Remote site, restore the VM from the local snapshot by selecting the correct snapshot
- C. From the Remote site, activate the Protection Domain, then re-protect the entity.
- D. From the local site, retrieve the correct remote snapshot, then restore the VM locally.
Answer: D
NEW QUESTION 80
Asystems administrator needs to add more VMs to their Nutanix cluster.
Which two actions should the administrator perform to determine if the current cluster can accommodate the new VMs? (Choose two.)
- A. Enable Deduplication and Erasure Coding.
- B. Utilize Optimize Resources for VM efficiency.
- C. Determine utilization with Cluster Runway.
- D. Perform an Inventory with Life Cycle Management.
Answer: B,C
Explanation:
Explanation
Ref:
NEW QUESTION 81
An administrator is updating disk firmware using LCM and receives the following message:
"there have been 10 or more cluster services restarts within 15 minutes in the Controller VM" The message appears as each drive is upgraded.
What is the reason this message isbeing generated?
- A. A node has been rebalanced
- B. A node has been rebooted
- C. A drive has been reformatted
- D. A drive has been ejected
Answer: B
Explanation:
Explanation
Ref: https://portal.nutanix.com/page/documents/kbs/details?targetId=kA032000000TT8DCAW
NEW QUESTION 82
Where in the Support Portal is the Best Practices guide for vSphere Networking located?
- A. Knowledge Base
- B. Product Notices
- C. Software Documentation
- D. Solutions Documentation
Answer: D
NEW QUESTION 83
A customer needs a DR solution designed around the following requirements:
* There are 8 ms of latency between Sites A and B
* The administrator needs the shortest RPO/RTO possible
* Application consistent snapshots are required
* Use of NutanixVSS
Which Data Protection Method should be used?
- A. Metro Availability
- B. Near Sync
- C. Async
- D. Cloud Connect
Answer: B
Explanation:
Explanation
Ref:https://portal.nutanix.com/page/documents/details?targetId=Prism-Element-Data-Protection-Guide-v5_18:w
NEW QUESTION 84
While trying to upgrade AOS in a cluster, a consultant receives a warning message that there are two powered-on VMs that need to be powered off for the upgrade to proceed.
What would cause this warning to be issued?
- A. There are not enough resources left in the single-node cluster.
- B. Upgrading a single-node cluster requires the VMs to be shut down.
- C. Upgrading a two-node cluster requires the VMs to be shut down.
- D. There are not enough resources left in the two-node cluster.
Answer: B
NEW QUESTION 85
A customer has an ESXi Cluster with two 10GbE NICs on each node with the following requirements:
* Solution must follow Nutanix Best Practices
* Network configuration should be redundant
* A vSphere Standard Switch must be utilized
Which load balancing method should be used?
- A. Route based on IP hash
- B. Route based on physical NIC load
- C. Route based on source MAC hash
- D. Route based on originating port ID
Answer: D
NEW QUESTION 86
Refer to the exhibit.
An administrator logged into Prism Element, notices the following in the home dashboard, and showing the exhibit.
Which action should the administrator take next?
- A. Configure the fqdn for the hosts indicated
- B. Check the hardware page for disk failures
- C. Troubleshoot the zookeeper server issue
- D. Re-run NCC specifying data_resiliency_check
Answer: D
NEW QUESTION 87
A customer racks all nodes in the new cluster. The customer does not allow IPv6 for node discovery.
The consultant is not allowed to use the consultant's own flat switch in the customer's environment.
Which step should the consultant take to resolve this issue?
- A. Bare metal image all nodes with Foundation VM.
- B. Open a console to all nodes and statically assign IP addresses.
- C. Connect to the top of rack switch and discover the nodes with IPv4.
- D. Image each node individually with Foundation VM.
Answer: B
NEW QUESTION 88
A consultant creates three storage containers (container-1, container-2, container-3). The customer requires that only container-1, which will be utilized as an NFS datastore, be presented to external hosts.
However, users are able to mount all three containers.
What is causing this problem?
- A. A Container-level whitelist entry was configured.
- B. Compression was turned on for all containers.
- C. A Global whitelist entry was configured.
- D. Deduplication was turned on for all containers.
Answer: C
NEW QUESTION 89
Microsegmentation was recently enabled in a Nutanix environment. The administrator wants to leverage Prism Central to create a policy that will block all traffic, regardless of direction, between two groups of VMs identified by their category.
Which policy should be used to meet this requirement?
- A. An Application Security Policy
- B. A Quarantine Policy
- C. A Whitehst-Based Policy
- D. AnIsolation Environment Policy
Answer: D
Explanation:
NEW QUESTION 90
A system administrator needs to shut down an AHV node in a Nutanix cluster without causing service disruption. The administrator checks data resiliency and verifies that the cluster can tolerate a node down.
Which three steps should the administrator perform next? (Choose three.)
Answer:
Explanation:
Explanation
1 allow vms2 sd CVM3 sd node
NEW QUESTION 91
......
Go to NCS-Core Questions - Try NCS-Core dumps pdf : https://www.pass4surecert.com/Nutanix/NCS-Core-practice-exam-dumps.html
Dumps Practice Exam Questions Study Guide for the NCS-Core Exam: https://drive.google.com/open?id=18k6HK12OtulDoQrMWp4GCIMtxAqTZXjt